-
Notifications
You must be signed in to change notification settings - Fork 963
New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
HA OS 13.0 breaks usb Aeotec Z-wave stick? #3531
Comments
I have the same problem using a Raspberry 4. Question to "laageide" , how can I downgrade to HA OS 12.4? |
In terminal you can downgrade with the following command "ha os update --version 12.4" |
The root cause of some USB issues was not resolved in Raspberry Pi kernel - however, those were supposedly present on RPi 3 only. Moreover, there was no change between 12.4 and 13.0 for Raspberry Pi that could change the behavior in either way. The Aeotec Z-wave stick has enumeration issues though (it's a hardware defect) and sometimes requires to be unplugged multiple times (or a reboot can also help), so I think this is the case as well. Hard to tell without any logs though. |
I did not try to physically disconnect/reconnect the z-wave stick since i did the update remotely. But I tried to reboot the entire system without any luck. Can give it another go when I'm back home and have access to the hardware. |
@laageide: Thank you very much! @sairon: Re-booting and swapping USB slots didn't change anything. Here are Core and Z-Wave logs I got. |
@sairon: To build on what you said, just downgraded to 12.4 and had the same problem after reboot. Swapped again USB slot of Aeotec Z-wave gen5+ stick and now all is running fine again after reboot. |
Host would be needed here. Ideally |
I had the same problem, Installed 12.4 and problem persisted. Turned out the Integration looking for the wrong USB port. Used the configure option and selected the right USB port. No problems now on 12.4. Will try the same on 13.0. |
For me all is OK now: after using the " Do you want to use the Z-Wave JS Supervisor add-on?" and selecting the USB stick no more problems even on 13.0 |
An update from my side here : I just updated to HA OS 13.0 again and everything is working perfectly on my system. |
"Do you want to use the Z-Wave JS Supervisor add-on?" When/where do you see this option? |
Settings->Devices & services Select Z-Wave, icecream menu (vertical dots and select (re)configure). Regards, John. |
Since upgrade HAOS 13.0 I have unstable issue with USB. |
Describe the issue you are experiencing
Aeotec Z-wave gen5+ stick dissapears from system after updating to HA OS 13.0.
It is not detected as connected anymore.
Downgrading to HA OS 12.4 solves the problem and z-stick is working as normal.
What operating system image do you use?
generic-x86-64 (Generic UEFI capable x86-64 systems)
What version of Home Assistant Operating System is installed?
13.0
Did the problem occur after upgrading the Operating System?
Yes
Hardware details
Using an dell laptop with deconz zigbee, aeotec z-stick gen5+ and skyconnect dongle connected.
Steps to reproduce the issue
...
Anything in the Supervisor logs that might be useful for us?
Did not backup logs before reverting to version 12.4 #sorry about that 🥴
Anything in the Host logs that might be useful for us?
Did not backup logs before reverting to version 12.4 #sorry about that 🥴
System information
this is system information with version 12.4 installed
System Information
Home Assistant Community Store
Home Assistant Supervisor
Dashboards
Recorder
Additional information
No response
The text was updated successfully, but these errors were encountered: