This is a MiSTer port of the Apple IIe core from MiST.
This the MiST port of a reconstruction of an 1980s-era Apple ][+ implemented in VHDL for FPGAs.
Original for the DE2: http://www1.cs.columbia.edu/~sedwards/apple2fpga/
Port for the MiST: http://ws0.org/tag/apple2/
- disk loading via osd. supported formats: .nib, .dsk, .do, .po NOTE: only .nib will persist saves to disk
- HDD loading via osd
- Tape loading via the ADC-in
- Selectable 6502 or 65C02 CPU
- Load custom video ROM (default built-in: US/UK)
- Joystick support
- Scanlines
- Color, amber, green and black&white monitor
- selection of color palette (NTSC //e, Apple IIgs, AppleWin, Custom)
- Load custom palette from file
- Language card in slot 0
- ProdDOS compatible clock card in slot 1
- Super Serial Card in slot 2
- 64K base + 64K auxilary RAM with 80 column and double hi-res support (256KB total with Saturn 128K)
- Saturn 128k RAM expansion in slot 5 (get the utility disks from here: http://apple2online.com/?page_id=3447 , under "Saturn RAMSoft")
- Mockingboard model A (two AY-3-8913 chips for six audio channels) in slot 4
- Win/Cmd Key - Closed Apple
- Alt Key - Open Apple
- F2 - RESET key
- F8 - cycle through color palettes (NTSC, Apple IIgs, AppleWin, Custom)
- F9 - cycle through display monitor modes (color, b&w, green, amber)
- Slot 0 - language card
- Slot 1 - clock card (PRODOS compatible)
- Slot 2 - Super Serial Card
- Slot 3 - 80 col + 64K RAM expansion (//e)
- Slot 4 - Mockinboard model A (six audio channels)
- Slot 5 - Saturn 128kb RAM expansion (total of 256kb)
- Slot 6 - Disk Drive controller
- Slot 7 - Hard Disk Drive controller
Apple-II has a big mess in disk formats. DSK image may contain either DO or PO format. Even PO and DO may contain opposite format. So if PO disk doesn't work, then try to rename it to DO. If DO or DSK doesn't work then try to rename it to PO.
For HDD, only HDV images (raw ProDOS partition images) 32MB in size are supported. 2MG images may work if the 64-byte header is removed.
dd if=diskimage.2mg of=diskimage.hdv bs=64 skip=1Put disk files into the /games/Apple-II/ folder.
On the "Apple ][" boot screen open the OSD with F12 and choose a disk. It will boot the disk automatically.
If you press reset (the right button on the MiST) you'll enter Applesoft with the ] prompt. From here you have some limited commands. See: http://www.landsnail.com/a2ref.htm
If you want to boot another disk choose a .nib image via the osd and type the following:
]PR#6
or
]CALL -151`
*C600G
The call command will enter the Monitor. Type the call a second time if the * prompt won't show the first time. At the Monitor you can also type 6 and then Ctrl-P followed by return. See https://web.archive.org/web/20140827184511/http://vectronicsappleworld.com:80/appleii/dos.html#bootdos
The HDD interface is in slot 7. Unlike the floppy interface, it does not stall until an image is mounted, so either reset the machine or use one of the following after mounting an image:
]PR#7
or
]CALL -151`
*C700G
Install the acme cross-assembler: https://sourceforge.net/projects/acme-crossass/
acme -o clock.bin clock.asm
srec_cat clock.bin --binary -o clock2.hex --ascii_hexThis is a reconstruction of an 1980s-era Apple ][+ implemented in VHDL for
FPGAs.
Stephen A. Edwards, [email protected]
http://www1.cs.columbia.edu/~sedwards
------------------------------
The current implementation uses the Altera DE2 board and takes advantage
of its off-chip SRAM, VGA DAC, SD card, audio CODEC, and PS/2 keyboard
interface.
It was designed to be fairly easy to port: the apple2.vhd file should
be implementation-agnostic: it only assumes the external availability
of 48K of RAM and a keyboard.
It contains a simple read-only Disk II emulator that expects
"nibblized" disk images written raw onto an SD or MMC card (i.e., it
does not use a FAT or any other type of filesystem).
The VGA controller (not part of an original Apple) doubles each line
and interprets the Apple's NTSC-compatible color signals to produce a color
640 X 480 VGA display with non-standard dot timing.
------------------------------
To compile under Altera's Quartus software, open the apple2fpga.qpf
project file and compile.
------------------------------
VHDL files, in order of elaboration:
timing_generator.vhd Timing signal generation, video counters
character_rom.vhd The beautiful 5 X 8 uppercase-only text font
video_generator.vhd Text, lores, and hires mode shift registers
main_roms.vhd D000-FFFF ROMs: Applesoft and the Monitor
cpu6502.vhd The 6502 CPU core
apple2.vhd Top-level of the Apple: mostly address decode
disk_ii_rom.vhd C600-C6FF ROM: Disk II bootstrap ROM
disk_ii.vhd Read-only Disk II emulator
vga_controller.vhd NTSC-to-VGA color interpolation, line doubler
PS2_Ctrl.vhd Low-level PS/2 keyboard interface
keyboard.vhd PS/2 keyboard-to-Apple interface
spi_controller.vhd SD/MMC card controller: reads raw tracks
i2c_controller.vhd Simple I2C bus driver; initializes the codec
wm8731_audio.vhd Controller for the Wolfson WM8731 audio codec
DE2_TOP.vhd Top-level entity for the Altera DE2 board
CLK28MPLL.vhd Altera-specific configuration for 28 MHz PLL
Other files:
dsk2nib.c Converts a 140K .dsk image file to the raw 228K
.nib format used by the Disk II emulator
makenibs A shell (e.g., bash) script that assembles
collections of .dsk files into a file suitable
for directly writing onto an SD card
rom2vhdl Script to convert raw ROM files into
synthesizable VHDL code. Used to produce main_roms.vhd
apple2fpga.qpf Project file for Altera's Quartus
DE2_TOP.qsf Mostly pin assignments for Altera's Quartus
DE2_TOP.sof A compiled bitstream for the DE2 board: the
result of compiling all the VHDL files in
Quartus; suitable for programming if you have a
DE2 board.
dos33master.nib Bootable disk image: Apple DOS 3.3 system master
bios.a65 6502 assembly source for a "fake" BIOS
bios.rom Binary data for the "fake" BIOS
Makefile Rules for creating the .zip, .vhd files, etc.
------------------------------
Disk images
The system expects a sequence of "nibblized" (227K) disk images on the
SD card starting at block 0. Switches on the DE2 board selects which
image appears to be in the drive; the image number is displayed in hex
on two of the seven-segment displays.
Most Apple II disk images are in 140K .dsk files, which stores only
the disk's logical data, i.e., is not encoded. dsk2nib.c is a small C
program that expands .dsk files to .nib files.
I used the "makenibs" script to find all the .dsk files in a tree of
directories, assemble them into an image suitable for downloading to
the SD card, and print an image number/file name cross-listing.
To write .nib images to an SD/MMC card under Linux, I use
dd if=dos33master.nib of=/dev/sdd
Of course, your card may appear as something other than /dev/sdd.
------------------------------
ROMs
This archive does NOT include a copy of the Apple ][+'s ROMs, which
are copyright Apple Computer. Instead, it includes a very trivial
BIOS that beeps, displays a text screen, then cycles through some
lores and hires graphics patterns when keys are pressed. This should
be enough to verify the graphics, sound, and keyboard are working (but
not the disk emulator). Source for this BIOS is in the bios.a65 file,
which I assembled using the xa65 cross-assembler.
The system requires two ROM images: a 12K image of the system roms
(memory from 0xD000 - 0xFFFF) and a 256-byte image of the Disk II
controller bootstrap ROM (memory from 0xc600 - 0xc6ff if the card is
in the usual slot 6).
Once you obtain them, run the "rom2vhdl" script to convert the binary
files into .vhd files that hold the data. The Makefile contains rules
for doing this.
------------------------------
Credits:
Peter Wendrich supplied the 6502 core:
-- cpu65xx_fast.vhdl, part of FPGA-64, is made available strictly for personal
-- educational purposes. Distributed with apple2fgpa with permission.
--
-- Copyright 2005-2008 by Peter Wendrich ([email protected]).
-- All rights reserved.
-- http://www.syntiac.com/fpga64.html
The low-level PS/2 keyboard controller is from ALSE:
-- PS2_Ctrl.vhd
-- ------------------------------------------------
-- Simplified PS/2 Controller (kbd, mouse...)
-- ------------------------------------------------
-- Only the Receive function is implemented !
-- (c) ALSE. http://www.alse-fr.com
I adapted the Apple ][ keyboard emulation from Alex Freed's FPGApple:
http://mirrow.com/FPGApple/