Klippventurer

Klipperize your FlashForge printer!

Compatibility • Installation • Known Issues • Special Thanks To

Compatibility

Printer	Printing	Easy Installer	Pin table	Printer.cfg	Thermistor Calibration	Display	Touch	Filament Runout	Camera
Adventurer 3/Pro*	✅	⏰	✅	✅	⏰	⏰	⏰	⏰	⏰
Adventurer 3 Pro 2	❓	⏰	❓	❓	⏰	⚠️	⚠️	⚠️	⚠️
Adventurer 4	⚠️	⏰	⚠️	⚠️	⏰	⚠️	⚠️	⚠️	⚠️
Adventurer 5M/Pro	⚠️	⚠️	✅	⚠️	⚠️	⚠️	⚠️	⚠️	⚠️
Creator Pro 2	⚠️	⚠️	❓	⚠️	⚠️	⚠️	⚠️	❌	❌
Creator 3/Pro	⚠️	⏰	⚠️	⚠️	⚠️	⚠️	⚠️	❌	❌

✅Working ⠀⠀ ⏰In Progress ⠀⠀ ⚠️Not yet Working ⠀⠀ ❌Not planned or lacks hardware feature ⠀⠀ ❓Untested, might work

Note: "Adventurer 3" Includes the Adventurer 3C, Lite, and Pro, as well as rebrands such as the Bresser Rex, Arçelik PT1000, MonoPrice Voxel, and likely any other printer based on the SZ16 mainboard.

Installation

For installation instructions, please see the wiki

Always calibrate your Z offset and mesh bed leveling after installing Klipper!!!

This repo, supported features, and guides change often, join our Discord or watch the repo for updates. Please open an issue or pull request if you encounter any problems with installation.

Known Issues

• Nation N32G MCU doesn't work with current .config
• Can't currently support screen, buzzer, USB, filament runout sensor, or camera. This will be solved when the easy installer is released.
• Adventurer 3 Pro works, but you need to switch the stepper driver types from TMC2208 to TMC2209.

Special Thanks To

@hw-lunemann for fixing UART muxing and tuning input shaper on Adventurer 3

@kyleisah and everyone who contributed to KAMP

@KevinOConnor and everyone who contributed to Klipper

@FlashforgeOfficial for good hardware at a fair price